Short for British Naval Connector or Bayonet Nut Connector or Bayonet Neill Concelman, a type of connector used with coaxial cables such as the RG-58 A/U cable used with the 10BASE2 Ethernet system. The basic BNC connector is a male type mounted at each end of a cable. This connector has a center pin connected to the center cable conductor and a metal tube connected to the outer cable shield. A rotating ring outside the tube locks the cable to any female connector.
|
|
Inappropriate
|
See Answer
To Email:
Subject:
Note to go along with the question: (Optional, no
more than 1,000 characters)
A representation of the combination of one or more Connector components that share a single engine component for processing incoming requests.
Create Date
:
Tuesday, May 13, 2008
Click here
to improve the Interview Question, Answer and other fields.
|
|
Inappropriate
|
See Answer
To Email:
Subject:
Note to go along with the question: (Optional, no
more than 1,000 characters)
An architecture for integration of J2EE products with enterprise information systems. There are two parts to this
architecture: a resource adapter provided by an enterprise information system vendor and the J2EE product that allows this
resource adapter to plug in. This architecture defines a set of contracts that a resource adapter must support to plug in to
a J2EE product-for example, transactions, security, and resource management.
Create Date
:
Tuesday, May 13, 2008
Click here
to improve the Interview Question, Answer and other fields.
|
|
Inappropriate
|
See Answer
To Email:
Subject:
Note to go along with the question: (Optional, no
more than 1,000 characters)
A standard extension mechanism for containers that provides connectivity to enterprise information systems. A connector is
specific to an enterprise information system and consists of a resource adapter and application development tools for
enterprise information system connectivity. The resource adapter is plugged in to a container through its support for
system-level contracts defined in the Connector architecture.
Create Date
:
Tuesday, May 13, 2008
Click here
to improve the Interview Question, Answer and other fields.
|
|
Inappropriate
|
See Answer
To Email:
Subject:
Note to go along with the question: (Optional, no
more than 1,000 characters)
data bus connector. Type of connector used to connect serial and parallel cables to a data bus. DB connector names are of the format DB-x, where x represents the number of (wires) within the connector. Each line is connected to a pin on the connector, but in many cases, not all pins are assigned a function. DB connectors are defined by various EIA/TIA standards.
Create Date
:
Saturday, May 10, 2008
Click here
to improve the Interview Question, Answer and other fields.
|
|
Inappropriate
|
See Answer
To Email:
Subject:
Note to go along with the question: (Optional, no
more than 1,000 characters)
Mounting plate, used primarily in the Cisco AGS+, MGS, and CGS chassis, containing connector hardware allowing attachment to the network. Appliques translate communication signals from a network interface into the signals expected by the communication standard being used (such as EIA/TIA-232 or V.35).
Create Date
:
Saturday, May 10, 2008
Click here
to improve the Interview Question, Answer and other fields.